How to set cisco 2950 switch to factory default

#HOW TO SET CISCO 2950 SWITCH TO FACTORY DEFAULT PASSWORD#
#HOW TO SET CISCO 2950 SWITCH TO FACTORY DEFAULT WINDOWS#

Type 'end' at the command prompt and tap the 'Enter' key. Repeat this step for each interface in which PoE is required.Д§. Then, while in interface configuration mode, type 'power inline auto' and tap the 'Enter' key. Type 'interface fastethernet1/2,' replacing the 'fastethernet1/2' with the name of an interface in which you wish to enable PoE, and then tap the 'Enter' key.

Then enter 'configuration terminal' at the command prompt, and tap the 'Enter' key.Д¦.

#HOW TO SET CISCO 2950 SWITCH TO FACTORY DEFAULT PASSWORD#

Enter the Privileged Exec password when requested at the command prompt, and tap the 'Enter' key. Type 'enable' at the command prompt, and then tap the 'Enter' key.ДҐ. how do I access my Cisco 2960 switch To put the switch into Express Setup mode, follow the steps described in the Catalyst 2960 Switch Getting Started Guide for powering on the switch and using Express Setup.After the switch is in Express Setup mode, open a Telnet session to the switch by using the IP address 10.0. Enter the telnet access password for the Cisco 2960 when requested, and then tap the 'Enter' key.Д¤. What is default password for cisco switch admin. Immediately press and hold and while the Headset, Mute, and Speaker buttons begin to. In order to perform a factory reset of a phone if the password is set, complete these steps: Unplug the power cable from the phone, and then plug in the cable again.The phone begins its power up cycle. Type 'telnet aaa.bb.c.d' at the command prompt, replacing the 'aaa.bb.c.d' with the IP address of the Cisco 2960, and then tap the 'Enter' key.ДЈ. Reset the 79 IP Phones to the Factory Default. Click the 'All Programs' icon, and then select the 'Accessories' icon, and then click the command line icon.

#HOW TO SET CISCO 2950 SWITCH TO FACTORY DEFAULT WINDOWS#

Select the 'Start' button on the Windows XPВ computer. Telnet access password for the Cisco 2960 switchДЎ. Privileged Exec mode password for the Cisco 2960 switchДЈ. Cisco 2960 switch with telnet access enabledДў. PoE lowers the totalВ costВ of network installation and maintenance and is easy to enable on a Cisco 2960 switch in a few minutes.ДЎ.

The switch hardware must also be configured to provide PoE service, which may require upgrading power supplies and/or port modules. In order for PoE to work, the device that is powered by PoE must support the same standard as the PoE switch that is connected to the device. PoE (Power over Ethernet) is a standard established in the early 2000s that provides the convenience of eliminating power cables for low voltage devices by providing power through network cables.

How to set cisco 2950 switch to factory default